When a repipe makes sense
- Two or more slab leaks or pinhole leaks in the last few years
- Blue-green stains on copper fittings or white crust at joints
- Low water pressure throughout the house
- Rusty or discolored water
- Older plastic pipe such as polybutylene, or PEX-aluminum lines with brass fittings that are corroding
- You are remodeling and the walls are already open
How a repipe works
Walkthrough and plan
We look at every fixture, the water heater and the main shutoff, then lay out where the new lines will run. Most lines go through the attic and drop down inside the walls.
Install the new lines
We run new PEX or copper to each fixture, using small openings in drywall instead of tearing out whole walls. Furniture and floors are covered while we work.
Test and switch over
Every line is pressure-tested before the old system is shut off. Most families have water back each evening.
Patch
Wall openings are patched and ready for paint.
PEX or copper?
PEX is flexible, handles hard water well and needs fewer fittings, so there are fewer places for a future leak. It is the most common choice for Gilbert repipes. Copper is still a great pipe and some homeowners prefer it. We install both and will tell you honestly which fits your home.
Whole-House Repiping questions
How long does a whole-house repipe take?
Most single-family homes in Gilbert take two to four days, depending on size and number of bathrooms.
Can we stay home during the repipe?
Yes. We plan the work so you have water most evenings and keep the house clean as we go.
Do I need a permit?
A repipe usually needs a permit from the Town of Gilbert. We take care of it and schedule the inspection.